110V/220V Dental Lab Equipment Wet Model Trimmer With Cutting Disc For Trimming Plaster Models In Dental Lab JT-19C

110V/220V Dental Lab Equipment Wet Model Trimmer With Cutting Disc For Trimming Plaster Models In Dental Lab JT-19C 4000233240262 Pre-Order +/- Sampai Alamat 10-15 Hari FREE ONGKIR+PAJAK Garansi uang kembali jika Rusak, Beda Produk Model Number : 368 DIY Supplies : ELECTRICAL Origin : Mainland China Voltage220V/50Hz10% 110V/60Hz10% Power500W Rotational2800rpm Dimensions44*35*35cm Weight20kg Working method: water mill (with resin sand) Feature: 1. Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve 2. Connect the waste-disposal tube to the unit 3. Connect the power cord, and switch on the power switch (O=off, l=on) 4. When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it, and use the included hex-wrench to adjust the screw on the back cover (18) 5. To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm, change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet) Instructions 1. Lay the machine flat (4 holes on both sides of the base support the installation of expansion screws), connect the inlet pipe (the inlet pipe is controlled by the solenoid valve and synchronize with the motor switch), pull out the outlet pipe 2. Power on, turn on the motor, check the operation for abnormal noise when no-load operation 3. The working platform has 3 angles and is adjusted by adjusting the screwdriver. 4. Replace the sand piece, cut off the power supply, open the front cover, remove th