GPS Ublox NEO 6M 7M 8M M8N V2 Dual Antenna Module - 7M

Minimum total order Rp50Ribu ya gan biar bisa proses !! Product Features: - Default output baud rate: 9600 (can be modified by u-center) - Default output frequency: 1Hz (can be modified by u-center) - Output protocol: nmea-0183 - Output level: serial communication TTL level - Supporting satellites: GPS satellites, beidou satellites, GLONASS satellites (the default is the combination of GPS+GLONASS satellite, and the combination of GPS+ beidou satellite or -GPS+GLONASS satellite can be set.) - It has IPEX and SMA antenna interfaces, which can be connected with various active antennas. - Equipped with rechargeable backup battery, it can temporarily keep the ephemeris data when power is off, and improve the speed of hot start positioning. - Compatible with 5V/ 3.3v voltage, suitable for various single chip microcomputer. 1. VCC: power supply (3.3V~5.0V). 2. GND: ground. 3. TXD: Module serial port sending pin (TTL level, cannot be directly connected to RS232 level, but can be connected to RXD of the microcontroller.) 4. RXD: Module serial port receiving pin (TTL level, cannot be directly connected to RS232 level, but can be connected to the TXD of the microcontroller.) 5. PPS: clock pulse output pin. Among them, the PPS pin is also connected to the status indicator light that comes with the module: PPS. This pin is connected to UBLOX NEO-6M. The module #39;s TIMEPULSE port, the output characteristics of this port can be set through the program. The PPS indicator light (ie PPS pin), under default conditions (not programmed), has 2 states: 1. Always on, indicating that the module has started working, but has not yet achieved positioning. 2. Flashing (off for 100ms, on for 900ms), indicating that the module has been positioned successfully. In this way, through the PPS indicator light, we can easily judge the current status of the module, which is convenient for everyone to use.