Holybro Kakute F7 Penerbangan Pengendali Betaflight OSD +

Holybro Kakute F7 Penerbangan Pengendali Betaflight OSD + Selama Barang/Produk Masih Tayang/Aktif Berarti (Stok Tersedia), Bisa Langsung Di Order/Di Beli (Tidak Perlu Chat Toko). Masukkan Keranjang Lalu Bayar. Saat itu Juga Barang/Produk Langsung Kami Kirim. Semua Produk Di Toko Kami Pre Order 6 - 15 Hari Tergantung Stok dan Posisi Gudang Luar Negeri. Anda Order Berarti Anda Setuju Dengan Waktu Pre Order Yang Kami Tetapkan Secara Default 6 - 15 Hari. Holybro Kakute F7 Flight Controller Betaflight OSD+Atlatl HV V2 5.8G FPV Transmitter for RC DroneSpecification:Holybro Kakute F7:Brand name: HolybroItem name:;Kakute F7;MCU: STM32F745 32-bit processorIMU: ICM20689 (SPI)Barometer: BMP280USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART) 6 hardware UARTS (UART1,2,3,4,6,7)All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without “uninvert hack”.Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.TF card for Blackbox loggingDimensions: 35x41x7mm (includes foam-mounted gyro board in height)Mounting Holes: Standard 30.5mm square to center of holesWeight: 9gFeatures:• Supports Betaflight, Butterflight, and Cleanflight.• Betaflight OSD. Change PIDs, adjust common configuration parameters, and change video transmitter channel and; power level, all using your transmitter sticks and goggles.• Soft-mounting built in. The IMU (“gyro”) chip on this board is mounted on vibration-isolating foam. This means that; there is no need to soft-mount the board itself.• High-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gyro and accelerometer. Can run at up; to 32 kHz sling rate.• Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA pads for use with external GPS/magnetometer units.• 2 oz. copper PCB allows up to 120A maximum SKU1315722