Happymodel X12 F4 AIO 1-2S 12A OSD OpenVTX Flight Controller FC ELRS

The world first 5-IN-1 AIO flight controller,OPENVTX(up to 400mw),12A Brushless Blheli_S ESC and Betaflight OSD coming out recently. It comes with onboard SPI ELRS receiver which support ELRS TX module 2.x firmware. This is an amazing flight controller for Brushless whoop. You could get unbelievable RX and VTX range by using this flight controller. Specifications: Brand Name:Happymodel Item Name:X12 AIO 5-IN-1 Flight controller built-in 12A ESC and OPENVTX Betaflight firmware target: ELRS Version:CRAZYBEEF4SX1280 VTX antenna:U.FL Weight:5.1g Support 1-2S Lipo/LIHV battery Size:30mm*30mm*8mm Flight controller X12 ELRS V2.0 flight controller built-in ELRS 2.4G receiver Target:CRAZYBEEF4SX1280 MCU:STM32F411CEU6 (100MHZ,512K FLASH) Sensor:MPU6000 or ICM20689 or BMI270(SPI connection) Mount hole size:25.5mm*25.5mm Power supply:1-2S battery input (DC 2.9V-8.7V) Built-in 12A(each) Blheli_S 4in1 ESC Built-in Betaflight OSD(SPI Control) Built-in 5.8G OpenVTX 0mw~400mw Built-in ExpressLRS 2.4G,Frsky D8/D16 Built-in voltage meter sensor ,voltage meter scale 110Built-in current meter sensor ,current meter scale 470 Onboard 4in1 ESC Power supply:1-2S LiPo/LiPo HV Current:12A continuous peak 15A (3 seconds) Support BLHeliSuite programmable Factory firmware:Z_H_30_REV16_7.HEX Default protocol:DSHOT300 Support Bluejay firmware When use Blujay firmware with 48khz,should set startup power to 1100/1200 Onboard SPI ExpressLRS 2.4GHz Receiver Packet Rate option:50Hz/150Hz/250Hz/500Hz ExpressLRS Firmware version:V2.0 RF Frequency:2.4GHz Antenna:SMD antenna Telemetry output Power: lt;12dBm Receiver protocol: SPI ExpressLRS Compatible with ExpressLRS V2.0 TX Module Couldn’t flash separately ExpressLRS firmware Onboard 5.8g OPENVTX Firmware version:OPENVTX Smartaudio v2.1 PIT Mode support RCE Mode support Channels:48ch Transmitting Power:0/RCE/25mw/100mw/400mw Power supply:DC 5V Current (5v): lt;650ma (400mw) Antenna connector:U.FL