MTL CNC encoder SW-1024-05DR3A 1024P/R

MTL CNC encoder SW-1024-05DR3A 1024P/R 32251473538 Pre-Order +/- Sampai Alamat 10-15 Hari FREE ONGKIR+PAJAK Garansi uang kembali jika Rusak, Beda Produk Application : Grinder Model Number : SW-1024-05DR3A 1024P/R Certification : CE Encoder installation Caution: 1. The encoder is installed should gently push quilt axis, non-collision with a hammer percussion and avoid damage to the shaft and encoder. Please note that the permissible axle load 2. Installation shall not exceed the limit load. 3. Do not exceed the speed limit, if more than allowed by the encoder speed limit, an electrical signal may be lost. 4. Do not use the encoder output lines and power lines around together or in the same tunnel, and it is not in the vicinity of the power strip use, to prevent interference. 5. Before installing the boot, you should carefully check the product manual model is consistent with the encoder, the wiring is correct, wrong wiring can cause damage to the internal circuitry Encoder installation Caution: 1. The encoder is installed should gently push quilt axis, non-collision with a hammer percussion and avoid damage to the shaft and encoder. Please note that the permissible axle load 2. Installation shall not exceed the limit load. 3. Do not exceed the speed limit, if more than allowed by the encoder speed limit, an electrical signal may be lost. 4. Do not use the encoder output lines and power lines around together or in the same tunnel, and it is not in the vicinity of the power strip use, to prevent interference. 5. Before installing the boot, you should carefully check the product manual model is consistent with the encoder, the wiring is correct, wrong wiring can cause damage to the internal circuitry