MCG 4P Breaker Transfer ATS Universal Set AC Diesel 400A Dual Automatic Electric Switch Circuit Part Generator Power 220V Switch

SELAMAT DATANG. Produk saya ini Impor langsung dari produsen yang ada diluarnegeri, untuk kualitas barang nya terjamin asli. Harga dan Stock barang bisa berubah sewaktu waktu, mohon hubungi/konfirmasi Admin toko saya terlebih dahulu sebelum Order yaa...

Toko saya juga menerima jasa Request Produk yang anda inginkan dan Produk luarnegeri yang belum ada di Indo yaa Kaks...

Brand Name : SHALUO
Model Number : 500A/400A/630A ATS
Origin : Mainland China
is_customized : Yes


220V 4P400ADual Power Transfer Switch Universal switch ATS
8 . Wiring methods of the switch

8.1The primary wiring diagram to see the picture 3 .

8.2 The control power is derived from normal poweremergency power cand N phases.

8.3 and line control power AC220V connected with terminal 102~103,104~105 respectively,102 and 104 are normal power and emergency power live line respective.

8.4 Terminal 101,106 are act as signal lamp to control the power supply. Note:101 and 106 couldn't be connected with any other lines.

8.5 When above(under) input line, under(above)terminaland line A,B,C phases will be connected with copper lines or lines acting as output.

9.The instruction of debug the switch

9.1 Connect the normal power(),emergency power() to the corresponding copper bar respectively;

Automatic debugging Normal power supply with lectric,emergency power supply with Electric,switchline switch on Normal power supply without electric,emergency power supply with electric,switch switch on Normal power supply with lectric,switch line switch on (Refer to the switch panel white indicating arrowhead)

Remote debugging Press the bush button SB1,then the switchline switch on Press bush button SB2,then the switch line switch on

Automatic/Remote(Manual)debugging

When dial the function selection switch to the automatic position: the switch should act as the item required When dial the function selection switch to the remote (manual) position, the switch should

act as the item required

9.2 When the switch is in the position of switch online or line,the signal lamp on the panel should indicate correspondingly;

9.3 After finished the debugging,close the power supply firstly,and transfer the switch to the 0position by handle.(Middle position,refer to the switch panel white indicating arrowhead).