4 Channel PC817 Optocoupler Isolation Module Voltage Converter 6-30VDC

Deskripsi 2 Channel PC817 Optocoupler Isolation Module Voltage Converter 6-30VDC
please note that the limit of 817 is below 3KHZ. If the control signal is greater than 3KHZ, please do not use this module, it will not work properly.

Parameter:
1, the drive terminal signal voltage: 3.3-24V
2, the output voltage range: 3.3-30V (output current depends on the specific situation, but the maximum is not 10MA, the total power is certain, the voltage and current are inversely proportional)
3, through the jumper cap can achieve whether the output is high potential output or low output.

Characteristics:
1. It can realize low level driving high level and realize voltage conversion.
2. Using this module, the IO voltage of the MCU can be graded to achieve isolated drive between different voltage levels.
3. Through the selection of the jumper cap of each channel, it is possible to achieve separate control whether it is shared with the input. The jumper cap is shorted so
that the negative terminal of the output terminal is connected to the negative pole of the power supply (G in the figure).
4. Each channel has an independent power indicator, which can be directly driven by the IO port of the MCU. The input terminal is 5V high, and the 3-5MA current
can be driven.

Application:
1. MCU output level To drive the motor When the inductive device such as the motor is isolated, anti-interference protects the circuit of the MCU.
2. The output level of the single-chip microcomputer is low, and the driving voltage of the driven module is high. For level matching, for example, some PLC input should have 24V voltage and can be converted by this module.
3. For the inverter, the input signal can be inverted.
4. Used for high voltage detection, for example: the output signal level of a sensor is
12V. The voltage of the single chip is 5V. This module can be used for isolation
detection.