Matek ExpressLRS 2.4Ghz ELRS Receiver R24S Mateksys RX R24-S R24

ELRS-R24-S Specifications ESP8285, SX1280/1281IMLTRT PA/LNA: AT2401C molex 479480001 SMT antenna RF Frequency: 2.4GHz ISM Telemetry power: 20dbm AT2401C Rx_gain: 12dB Receiver protocol: CRSF Input voltage: 4~9V DC @ 5V pad Power dissipation: 40~45mA(before binding), 60~65mA(binding), 90~95mA(wifi mode) PCB size: 21mm x 15mm Weight: 1.2g Packing: 1x ELRS-R24-S Firmwares ExpressLRS MATEK_2400_RX Firmware update via UART or WIFI ELRS-R24-S: disable “USE_DIVERSITY” (unchecked) when flashing in ExpressLRS configurator “Any ELRS 2.4Ghz receivers can work with any ELRS 2.4Ghz TX Modules, from any manufacturer and even the DIY ones. This is as long as they have the same binding phrase and configuration options (Regulatory Domain, Performance Options and Extra Data).” More details about ExpressLRS, pls check out ExpressLRS wiki Wiring with FC Receiver RX — FC UART_TX for Telemetry Receiver TX — FC UART_RX for Control Receiver 5V — FC 5V or 4v5 Receiver G — FC GND Receiver protocol: Serial-based receiver – CRSF Traditional Binding Receivers have ExpressLRS fw V1.1.0 preloaded without BINDING_PHRASE Power on and off your receiver three times Make sure the LED is doing a quick double blink, which indicates the receiver is in bind mode Use the [BIND] button on the Transmitter Lua script, which sends out a binding pulse Receiver will switch to slow blink once it has received binding pulse. Power off and power on receiver again. If the receiver LED switch to solid on from slow blink, it’s bound with your transmitter. Important: If the RX firmware has a bind phrase, the RX will never enter binding mode using the above procedure. It must be flashed without a binding phrase to do traditional binding.