Rated power supply voltage 100 to 240 VAC 50/60 Hz 100 to 125 VDC Ripple 20% max. (If power supply incorporates a single-phase full-wave rectifier) Allowable voltage variable range 85% to 110% of rated voltage Power consumption Relay ON: Approx. 2 VA (at 240 VAC 60 Hz)/Relay OFF: Approx. 1.3 VA (at 240 VAC 60 Hz) Relay ON: Approx. 1.6 W (at 240 VAC 60 Hz)/Relay OFF: Approx. 1.1 W (at 240 VAC 60 Hz) Reset voltage 10% max. of rated supply voltage Number of time ranges 18 Operation mode ON delay, Flicker OFF start, Flicker ON start, Interval, One shot output Control output (Type) Time-limit: DPDT Control output (Contact output) Resistive load: 250 VAC 5 A (cosφ=1)/5 A at 30 VDC/ Inductive load (Reference value): 2 A at 250 VAC (cosφ=0.4)/3 A at 30 VDC (L/R=7 ms) Minimum applicable load: 10 mA at 5 VDC (failure level: P Reference value) Operating resetting Time-limit operation/Self-reset Ambient temperature range Operating: -10 to 55 ℃ (with no icing) Storage: -25 to 65 ℃ (with no icing) Ambient humidity range Operating: 35 to 85% Accuracy of operating time ±0.2% FS max. ±0.2% ±10 ms in a range of 1.2 s and 3 s Setting error ±5% FS ±50 ms max. Reset time 0.1 s max. Influence of voltage ±0.2% FS max. ±0.2% ±10 ms in a range of 1.2 s and 3 s Influence of temperature ±1% FS max. (±1% ±10 ms in a range of 1.2 s and 3 s) Insulation resistance 100 MΩ min. (at 500 VDC) Dielectric strength Between current carrying metal parts and non-current carrying metal parts: 2,000 VAC 50/60 Hz 1 min Between control output terminals and operating circuit: 2,000 VAC 50/60 Hz 1 min Between contacts of different polarity: 2,000 VAC 50/60 Hz 1 min Between non-continuous contacts: 1,000 VAC 50/60 Hz 1 min Impulse withstand voltage Between power terminals: 5 kV Between current carrying terminals and exposed non-current carrying metal parts: 5 kV Noise immunity ±1.5 kV (between power terminals), square-wave noise by noise simulator (pulse width: 100 ns/1 µs, 1-ns rise)